Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
EN
Installation Dimension
This product supports two installation methods: embedded in cabinet
or not embedded in cabinet.
Option ① : Not Embedded in Cabinet
Remove any objects that are closer than 1 m from the front of the base
station.
Option ② : Embedded in Cabinet (with Function Hatch not visible)
width
depth
height
height
(above the ground)
12
height
width
depth
(above the
(mm)
(mm)
(mm)
Pipes
installed on
the back side
≥285
≥431
≥555
of the base
station
Pipes
installed on
either side
≥285
≥431
≥510
of the base
station
Option ③ : Embedded in the Cabinet (with Function Hatch visible)
width
height
Hole-cutting Size
Cabinet not installed yet
height
If the cabinet is not installed yet:
ground)
Cut a square hole with a side length of 40mm. This hole should be
(mm)
reserved in the lower left or right corner of the cabinet side, and the
position is close to the ground.
140
If the cabinet has been installed already:
Cut a circular hole with a diameter of 40mm. The distance between
the hole center and the ground shall not be higher than 800mm, and
the specific hole-cutting position shall be determined according to the
140
actual installation environment.
height
width
(mm)
(mm)
depth
Pipes installed on
the back side of the
≥285
base station
Pipes installed on
either side of the
≥285
base station
Cabinet installed already
depth
(mm)
≥431
≥535
≥431
≥490
Publicité
