Publicité
Les langues disponibles
Les langues disponibles
Before Use
EN
1. Install Water Hookup Accessories for Auto Refilling
and Draining
Please refer to the provided user manual for detailed installation
instructions.
Note: Close the main water valve and angle valve in your home before installation
and make sure all the water in the pipes has been drained.
2. Place the Base Station and Connect to an Electrical
Outlet
Place the base station in a location that is as open as possible with a
good Wi-Fi signal. Remove any objects that are closer than 1 m from the
front of the base station. Insert the power cord into the base station and
plug it into the socket.
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood floors or carpets, placing the base
station on tile floors or marble floors is recommended.
22
3. Remove Robot Protections and Install the Mop
Assembly
4. Connect the Robot to the Base Station
Press and hold the button
Place the robot onto the base station with the mop assembly facing
toward the washboard. Then you will hear a voice notification when the
robot successfully connects to the base station.
Firmly insert the power
cord upwards until the
indicator turns on.
Note: It is recommended to fully charge the robot before its first use. When the
robot cannot be turned on after the battery is depleted, manually connect the
robot with the station to charge it.
②
④
①
③
on the robot for 3 seconds to turn it on.
Publicité
