Publicité
Les langues disponibles
Les langues disponibles
Routine Maintenance
EN
Washboard Base
The base station will perform washboard self-cleaning along with each
mop pad cleaning. For deep cleaning, please refer to the following
steps.
1. Press the washboard base clips to take out the washboard base.
Washboard Base Clip
2. Remove the washboard. Rinse the washboard and the washboard
base with clean water, and use the cleaning tool to clean them.
27
3. Flip the washboard over, remove the roller cover and the roller in
turn, and then pull off the end caps of the roller.
Wipers
Note:
·
If the roller cover is blocked by wipers on both sides of the washboard, rotate the
Washboard Base Clip
roller to move them aside.
·
The roller cover can be removed with an appropriate tool, such as the provided
cleaning tool.
4. Remove the hair tangled in the roller, and then reassemble the parts
according to corresponding colors, as shown in the figure below.
Publicité
