Ravaglioli KPE32 Traduction Des Instructions Originales page 54

INDEX
CH. 6 PRE-INSTALLATION AND MOVEMENT
- The lift is dispatched as shown in the illustration (fig. A) .
- Package (1) contains the accessories and the small parts for assembly completion.
- Lifting must be done as shown in the illustration. (fig. B).
- Raise with care and move the various units to the unpacking site.
- Proceed as follows when moving the machine to the chosen installation point (or for subsequent re-positioning):
• lift with care, using suitable means of load support which are in perfect working order and using the special hooking points as shown
in the illustration (fig. B).
• avoid sudden jolts and pulling, watch out for uneven surfaces, bumps etc..
• take special care with outjutting parts: obstacles, difficult throughways, etc..
• wear suitable clothing and protective gear.
• after removing the various packaging materials, check that these are taken to special waste collecting areas inaccessible to children
and animals where they will subsequently be disposed of.
• on receiving the goods, check that the packaging has not been opened. Once unpacked, check that nothing has been damaged.
1200
Handling procedure:
Fit in the eye bolt (2) (optional) on the screw (3).
Position the strap (4) in the eye bolt and on the load support as shown in the figure.
Carefully lift the column until it is upright.
Remove the strap from the eye bolt.
Remove the eye bolt (2).
2
4
Kg
3
KPE32 - KPC32
1
Kg 250
0474-M002-0
Fig. A
Fig. B
EN_13