Napoleon Riverside Serie Manuel D'installation Et D'utilisation page 28

7.0 gas installation
EN
WARNING
!
• Risk of fire, explosion, or asphyxiation. Ensure there are no ignition sources such as sparks or open flames.
• Support gas control when attaching gas supply pipe to prevent damaging gas line.
• Purging of the gas supply line should be performed by a qualified service technician. Ensure that a continuous
gas flow is at the burner before closing the door. Ensure adequate ventilation. For gas and electrical locations,
see "appliance dimensions" section.
• All gas connections must be contained within the appliance when complete.
• High pressure will damage valve. Disconnect gas supply piping before testing gas line at test pressures above
1/2 PSIG.
• Valve settings have been factory set, do not change.
Installation and servicing to be done by a qualified installer.
• Move the appliance into position and secure.
• If equipped with a flex connector, the appliance is designed to accept a 1/2" (13mm) gas supply. Without the
connector, it is designed to accept a 3/8" (9.5mm) gas supply. The appliance is equipped with a manual shut
off valve to turn off the gas supply to the appliance.
• Connect the gas supply in accordance to local codes. In the absence of local codes, install to the current
CAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 / NFPA
54 in the United States.
• When flexing any gas line, support the gas valve so that the lines are not bent or kinked.
• Check for gas leaks by brushing on a soap and water solution. Do not use open flame.
After installing the electrical wiring and gas lines, ensure to test the appliance before finishing the framing and
finishing the appliance.
7.1 propane cylinder specifications
WARNING
!
• If these instructions are not followed exactly, a fire causing death or serious injury may occur.
• A fire will result if the gas supply hose makes contact with the underside of the appliance.
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use
a cylinder with a damaged valve. The propane gas supply cylinder must be constructed and marked in
accordance with the U.S. D.O.T. Specifications for Propane Gas Cylinders or the Standard for Cylinders,
Spheres and Tubes for Transportation of Dangerous Good and Commission, CAN/CSA-B339, as applicable.
This appliance has been designed for use with a 20lb (9.1kg) or 30lb (13.6kg) size propane cylinder (not supplied)
if not hard piped.
The propane gas supply cylinder must be provided with a cylinder-connection device compatible with the connection
for the appliance. The propane cylinder must be provided with a shut-off valve terminating in a propane cylinder
valve type QCC1, and a safety relief device having direct communication with the vapour space of the cylinder. The
cylinder supply system must be arranged for vapour withdrawal and the cylinder shall include a collar to protect
the cylinder valve. The propane gas cylinder must be provided with a listed overfill protection device (OPD). Do
not store a spare propane gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full.
Inspect the hose assembly before each use. If there is evidence of excessive abrasion or wear, or if the hose is
damaged, it must be replaced prior to the appliance being put into operation. Use only the pressure regulator and
hose assembly provided with this appliance. Replacement pressure regulators and hose assemblies must be specified
by the manufacturer. The regulator supplies a pressure of 11 inches water column to the appliance and has a QCC1
type fitting. Cylinders to be used with this appliance must be supplied with QCC1 cylinder valve. A QCC1 cylinder
has a positive seating connection, which will not allow gas flow until a positive seal has been achieved. It is also
28
W415-10001315 / D-0 / 07.10.24