Kollmorgen AKMA Serie Manuel D'installation page 13

Recommendation
We recommend rinsing with clean warm water immediately after cleaning because this:
Increases the motor's resistance to chemical cleaning agents and corrosion in general.
l
Removes residues of chemical cleaning agents and prevent the formation of solidified deposits on the motor
l
surface.
Kollmorgen can only give a guarantee for the motor's lifecycle if the tested cleansing agents are used.
NOTICE
Any cleansing agent other than P3-topactive 500 can be tested by Kollmorgen upon request and, if
appropriate, be approved.
1.4.7 Cleaning Plan
These are the recommended cleaning plans (short form) with tested cleaning agents:
1.4.7.1 Flushing with Water (40 °C to 50 °C)
Flushing with low pressure.
l
From top to bottom in the direction of the drain.
l
Clean the drain.
l
1.4.7.2 Foam Cleaning
Foaming from top to bottom.
l
Acid
Temperature
1.4.7.3 Disinfection
Spraying with water (40 °C to 50 °C) with low pressure.
l
From top to bottom.
l
Spray Disinfection
Foam Disinfection
1.4.8 Repair and Disposal
Repair of the motor must be done by the manufacturer.
Opening the motor invalidates the warranty.
l
The manufacturer accepts returns of old devices and accessories for professional disposal.
l
The sender is responsible for the transport costs to return the motor.
l
Send the devices to:
KOLLMORGEN s.r.o
Evropská 864
664 42 Modřice, Brno
Czech Republic
P3-topactive 500 (6%, if necessary for 15 minutes).
Cold, maximum of 40 °C.
P3-topax 990 (1-2%, if necessary 30-60 minutes).
P3-topactiv DES (1-3%, if necessary 10-30 minutes).
AKMA Installation Manual | 1 English
Kollmorgen® | kdn.kollmorgen.com | June 2024 13