Publicité
Les langues disponibles
Les langues disponibles
HOW TO INSTALL ANTI-TIP BRACKET
1. Remove the anti-tip bracket from
where it is taped on Oven Rack
inside the Oven.
2. Determine which mounting method
to use: floor or wall. If you have a
stone or masonry floor, you can use
the wall mounting method. If you
are installing the range in a mobile
home, you must secure the range to
the floor.
3. Determine and mark centerline of
the cutout space. The mounting can
be installed on either the left side
or right side of the cutout. Position
mounting bracket against the wall
in the cutout so that the V-notch
of the bracket is 13-1/ " (33.3 cm)
from centerline as shown.
4.
Attach anti-tip bracket to floor or
wall.
- Wood Construction Installation:
Drill a 1/8" pilot hole where screws
are to be located.
If bracket is to be mounted to the
wall, drill pilot hole at an
approximate 20°downward angle.
Screw must enter wood.
- Masonry Construction Installation:
Due to the variety of masonry
materials that may be present at
installation site, hardware is not
provided for attaching the anti-tip
bracket to
masonry. If bracket is to be
mounted to masonry or ceramic
floors, attach anti-tip bracket using
two 5/16" OD
sleeve anchors (with 1/4" bolt -
either hex bolt head or hex nut head)
rated for minimum 300lb tension for
the masonry material present at
installation site.
8
EN-26
Centerline
13-1/8" (33.3cm)
ANTI-TIP
BRACKET
(FLOOR MOUNTING ONLY)
Leveling leg
Floor Mount
More than
1-1/4"
Wall
Anti-Tip
Bracket
Publicité
