Publicité
Les langues disponibles
Les langues disponibles
EN
2.6
Safety regulations with respect to the operation of the system
•
Make a risk assessment of the procedure before you start work (EN-ISO 12100).
•
Keep bystanders at a distance and be extra careful in the vicinity of people and animals.
•
Make sure the work area is clearly laid out and has good lighting.
•
Avoid stress and work in a structured way. This reduces the risk of errors, combinations of dangers
and accidents.
•
Before use, check the equipment for damage. Do not use the equipment if it is not in good
condition, and consult your Holmatro dealer.
•
Stand on a stable base.
•
Hold the equipment only by its carrying handle (if present).
•
During operation, never get between the object and the equipment.
•
Monitor the situation of the equipment and the structure continuously while using the equipment.
•
Never couple or uncouple couplers while the system is under pressure.
•
Use only genuine Holmatro accessories and ensure that they have been attached correctly.
•
Make sure that parts of the body never come between moving parts. There is a risk that parts of the
body may be crushed or cut.
•
Stop immediately if the system makes strange noises or displays aberrant behaviour.
•
Stop immediately if the equipment leaks oil. Oil escaping under pressure can penetrate the skin and
cause serious injury. Go immediately to a hospital with a person who is injected with oil for medical
help. Give a specification of the oil to the medical staff.
•
Always use a pressure gauge to monitor the pressure in the system.
•
Do not lift unstable loads.
•
Take extra care when lowering a load.
•
Always adhere to the safety regulations that apply to other equipment that is used in the operation.
•
Make sure the base or underground of the cylinders is stable.
•
Make sure the load is stable before and during the lifting procedure.
•
Never leave the load and lifting cylinder unattended.
•
Take precautions against hose failure.
•
Prevent for side loads.
•
If more cylinders are used for one load, make sure the lifting height will be kept equal.
•
Use tilting saddles if the load surface has an angle (0 - 5 degrees) with the plunger end.
2.7
Safety regulations with respect to maintenance
•
Wear personal means of protection when performing maintenance tasks.
•
Never work in a way that could jeopardize safety.
•
Make sure that the equipment cannot roll away or tip over. The control and drive must be switched
off and safeguarded against unexpected activation.
•
Make sure that moving parts do not move unexpectedly.
•
Used or leaked fluids, and any other products consumed during the activities, must be collected and
disposed of in a environmentally responsible way.
38
916.000.851_009
HYDRAULIC CYLINDERS
Publicité
