Hürner HST 300 HP 2.0 Manuel Utilisateur page 49

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
11.2.8 Emergency Off
The welding process has been interrupted by pressing the
STOP/RESET key.
11.2.9 Heater Coil Error
The dynamic current value during welding differs by more
than 15% from the required value, indicating a short-circuit
in the heater coil.
11.2.10 Power Supply Failure at Last Welding
The last welding is incomplete. The welding unit was dis-
connected from the power supply voltage while it was
in progress. To go on using the unit, this error has to be
acknowledged by pressing the STOP/RESET key (see also
Sect. 9.4).
12 Technical Specifications
Nominal Voltage
Frequency
Output Power
Ingress Protection
Primary Current
Ambient Temperature
Output Voltage
Max. Output Current
Memory for Welding Reports 10,000 reports
Data Interface Port
(see also the information on the data ports in Sect. 6)
Tolerances:
Temperature
Voltage
Current
Resistance
13 Service and Repair Contact
HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specs of
the product without prior notice.
Info
Version April 2016
360 - 440 V (400 V) (3 P + N)
50 Hz / 60 Hz
4500 VA, 80% duty cy.
IP 54
max. 16 A
– 20°C to + 60 °C
(– 4°F to + 140°F)
8 V - 48 V
110 A
USB v 2.0 (480 mbit/s)
± 5 %
± 2 %
± 2 %
± 5 %
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER HST 300 HP 2.0 User's Manual
25
EN