Hürner HST 300 HP 2.0 Manuel Utilisateur page 40

to set the welding voltage and the welding time, accord-
ing to the fitting manufacturer's instructions, then press
the START/SET key to confirm your input. The "Start ?"
message displayed after the confirmation by START/SET
indicates that the unit is ready for welding.
7.2 Entering the String of Numbers
If this option was chosen in the manual parameter input
menu, the "Enter Fitting Code" display shows. The 24 char-
acters of the fitting code to be entered display as asterisks
( * ). Use the alphanumeric keypad (see Info in Sect. 5.2)
to enter the code and press START/SET to confirm your
input and have it decoded. If the code entered is not cor-
rect, an "Input Error" message appears; check the string
of numbers and correct as needed. If the code is correct,
the decoded data is displayed, and the "Start ?" message
indicates that the unit is ready to start welding.
8 Downloading the Reports
Interface
USB A Interface Port
for connecting USB mass storage media (such as a
memory stick)
The interface port complies with the USB version 2.0
specification (i.e., maximum data rate of 480 megabits
per second).
Before transferring data, it is highly recommended
to switch the welding unit off and on again. If this
fails to happens, there is a risk of data transfer
Important
failure, or reports in the welding unit may be cor-
rupted.
When transferring welding reports to a USB stick,
always be sure to wait until the display shows the
"Download finished" message before you discon-
Important
nect the USB stick from the product. If you discon-
nect it too early, the unit may ask you whether you
want to delete the reports in memory, although
they were not properly transferred. In this case,
if you delete the contents of the report memory,
the welding reports would be irrevocably lost and
would not be available elsewhere either.
16
EN
HÜRNER HST 300 HP 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Voltage/Time
U= 40 V t= 1000 s
Display 13
Version April 2016