Hürner HST 300 HP 2.0 Manuel Utilisateur page 37

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
5.11 Returning to the Start of Parameter Input
After welding is finished, disconnecting the welded fitting
from the unit or pressing the STOP/RESET key will reset the
unit back to the start of entering the welding parameters.
5.12 Using ViewWeld to View Welding Reports and
Print Tags
The ViewWeld feature offers viewing an abstracted version
of the welding report recorded during the last welding
process and printing it as a label tag to be affixed to the
joint on the optionally available tag printer. The ViewWeld
abstract shows the report number, the date and time of
the welding and the welding parameters along with an
evaluation of the quality of the joint/welding operation
(see Display 6).
To call the ViewWeld abstract of a welding report, press
the ñ key in the bar code input screen (see Display 2). To
print a tag of this operation, press the START/SET key in
the ViewWeld screen.
6 Additional Information in the Welding Report
Every welding report saved to system memory, which can
be downloaded as a PDF report file or in the DataWork
format, contains a number of welding and traceability data
that the operator can decide to enter or not to enter in
the set-up menu.
6.1 Entering Preformatted and User-defined
Traceability Data
All traceability data enabled in the configuration menu at
"Data Recording" (see Sect. 10) have to be entered before
the welding process. The welding unit prompts the user to
enter them either before or after entering the fitting bar
code (see Display 2). Depending on what data is entered,
either its repeated input is mandatory (e. g., the welder
ID code; see Sect. 5.2) or previously entered data can be
changed and confirmed or confirmed without changes
(e. g. the commission number; see Sect. 6.2).
Certain traceability data can also be accessed quickly, via
a selection screen, by pressing the ï cursor key (see Dis-
play 7), either for viewing or for entering or changing/
confirming them (for the AutoWeld feature mentioned
along with them on this screen, see Sect. 5.5).
Version April 2016 HÜRNER HST 300 HP 2.0 User's Manual
0015 24.02.13 09:33
M/B MON HST 315
0058s 025.0V 1.57Ω
Welding OK
Display 6
*** Recording ****
AutoWeld
>Welder ID Code
Enter Job No.
Display 7
EN
13