Hürner HST 300 HP 2.0 Manuel Utilisateur page 45

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
10.1.1 Selecting the Display Language
When the "Select Language" sub-menu was selected, the
screen changes and the display reproduced in Display 20
appears.
Use the arrow keys ñ and ò to select one of the options,
"Deutsch," "English," and "Français" and confirmby press-
ing the START/SET key.
10.1.2 Setting the Clock
When the "Set Clock" sub-menu was selected, the screen
changes and the display reproduced in Display 21 appears.
The time of day and the date can be set using the keypad.
The portions "Hour," "Minute," "Day," "Month," and
"Year" are set separately. Press the START/SET key to con-
firm your settings.
10.1.3 Setting the Buzzer Volume
When the "Set Volume" sub-menu was selected, the screen
changes and the display reproduced in Display 22 appears.
The buzzer can also be heard. Turn the buzzer volume up
or down to the desired value using the ï, ð arrow keys
(from 0 to 100) and confirm your setting by pressing the
START/SET key.
10.1.4 Selecting the Temperature Unit and Entering the Inventory
Number
The unit of temperature values (Centigrade or Fahrenheit)
can be selected in a sub-menu similar to the language
selection (see Sect. 10.1.1). The internal identifier of the
welding unit in its owner's inventory can be entered in the
same way as the commission number (see Sect. 6.2).
10.2 Understanding the "Recording" Sub-menu
"Welder Code on" means that the welder identification
code has to be entered as set with "Welder Code Op-
tions," "off," that this is impossible.
"Commission Number on" means that the commission
number (job number) will have to be entered or con-
firmed before every new welding, "off" that the user
is not prompted to enter it.
"Joint Number on" means that the unit assigns an auto-
matically incremented joint number to every welding
operation belonging to a commission already known,
and displays this number on the screen next to the
report number, "off" that no joint numbers will be
assigned at all.
Version April 2016 HÜRNER HST 300 HP 2.0 User's Manual
***** LANGUAGE *****
>Deutsch
English
Francais
Display 20
Date/Time
21.06.13 14:28
Display 21
Buzzer Volume
< ------20-------- >
Display 22
Data Recording
Welder Code on
>Commission No. on
Joint No. off
Display 23
EN
21