Change Settings - Ugin e.ON SINTER Mode D'emploi

Instructions for use (rev 05/18)
For each program number, the cycle parameters are displayed as a chart:
- C represents temperature (°C), and
- T represents time (minutes).
Each program is two pages: the first page displays the pairs from C01/T01 to C20/T20 and the
second page from C21/T21 to C40/T40. The "NEXT PAGE" key switches from the first page to the
second page.

6.4.1. Change settings

When the program number is displayed on the screen, "press" the parameter to be modified
(touch screen). A numeric keypad is displayed to select the desired value.
Enter the new value using the numeric keypad and press "Ok" to save.
A confirmation message is displayed: "Caution: press the" Ok "key, the data will be saved". Press
"Ok" to confirm or "Cancel" to cancel.
UGIN DENTAIRE
e.ON SINTER
33