Parameter Setting - Ugin e.ON SINTER Mode D'emploi

Instructions for use (rev 05/18) e.ON SINTER

6.5. Parameter setting

This interface requires a password to be accessible. No data may be modified without
authorization: risk of damages on the furnace or trigger heating untimely. The modification of the
parameters is therefore reserved for technicians of customer's service UGIN DENTAIRE.
NOTE: even if changes are made to the settings, when saving them, a screen is displayed to insert
the password. When no password has been inserted and validation is done with the "Ok" key, the
changes made are not saved and the original settings remain applicable.
36
UGIN DENTAIRE