Control Keys - Ugin e.ON SINTER Mode D'emploi

Instructions for use (rev 05/18)

6.2. Control keys

Picture
Descent platform
Working interface
Parameter setting
Language selection
UGIN DENTAIRE
Keys
Start cycle
(RUN)
Pause
(PAUSE)
Stop
(STOP)
Ascent platform
(ARROW KEY
UPWARD)
(ARROW KEY
DOWNWARD)
Menu
(logo Microsoft)
Real-time curve
Program editor
Date setting
The selected program is started.
In running state, the program will be in a suspended
state, the temperature remains constant.
Under operating state or suspended state, the program
will end.
Press this key, the platform will rise, press again, the
platform will stop at the desired level.
Press the key, the platform go down, press again, the
platform will stop at the desired level.
NOTE: if the furnace temperature is above 300°C, it is
not possible to start a cycle (risk of damages the
insulation materials).
Then, press descent platform key (ARROW KEY
DOWNWARD): an alert message appears in the status
bar (bottom of the screen)
Pull-down menu appears, as shown below:
Parameters current cycle display
Display of the cycle curve (temperature/time)
Program settings
Software settings. Only access with technician code
(reserved for technicians customer's service UGIN
DENTAIRE)
Available languages: English, French, Spanish and Italian
Setting the date, time and day of the week
Description
e.ON SINTER
31