Start-Up - Ugin e.ON SINTER Mode D'emploi

Instructions for use (rev 05/18)

5. START-UP

After checking that the mains voltage matches that noted on the rating plate, plug the cord into a
standard 20A socket with a ground terminal.
This unit requires its
Grounding is mandatory to avoid accidents and the dangers of overheating the power
line. Due to the high power of furnace: connect it directly to the mains, do not use
multiple sockets.
NOTE: If not used for a long time, switch off the power supply.
a) Activate the breaker (ON/OFF) at the back of furnace.
b) Following power up, the initialization interface appears on the screen. The main screen
automatically appears as follows:
c) Press button « arrow key downward »
The platform moves down.
Remove the protections and dust with a sweeper or a soft and clean brush (do not use
compressed air).
IMPORTANT: DO NOT PLACE ANY OBJECT WHICH MAY HINDER THE ASCENT AND
DESCENT OF THE PLATFORM
UGIN DENTAIRE
own power line and must be connected to a circuit breaker.
on touch screen.
e.ON SINTER
29