JAC ECO+ Mode D'emploi page 13

Add the dose of food-grade oil (100 to 150 ml) required to impregnate the felt pads on the loaf pusher
(operate the carriage advance button to allow access to the oil filler plug).
Every 25,000 loaves and/or at least once a year, by an approved agent:
Remove the plug from the socket.
Replace the loaf pusher felt pads.
8.4 Blades changed by an authorised agent (fig.12)
Always wear cut-resistant gloves (EN 388:2003 version B= 5) and safety footwear when replacing
blades or when working in the vicinity of blades.
Having ensured that the plug on your machine (fig.2, n°15) has been disconnected from the mains:
A. Remove the bagging paddle.
B. Unscrew the front table at the sides of the machine.
C. Remove the front table.
D. Unscrew the cover.
E. Open the cover that protects the blade holder frames. On the upper part of the front frame,
remove screws A, which secure the frame to the polypropylene strips (never remove the strips
from the frame, as you risk altering factory settings).
F. Lay the frame down forwards. Replace the blades on the rear frame (place something to
protect yourself on the front frame blades). Remove the locknuts on screws B (Misch
machines). Remove the locknuts on screws B (EPF – EPFS – EPM – EPMS – EPN – EPNS).
Remove the blade-tightening Allen screws B. Replace the blades, checking that they locate
correctly in the swing arm pins. Retighten the blades by tightening screws B, using the blades
remaining on the frame as a reference. Then tighten the nuts (machine fitted with lubrication
option).
In order not to distort the frame and avoid the risk of dangerous breakages, only replace 1 to 3
blades at a time alternating from left to right.
Resume the procedure from point 6 for the front frame and refit the front frame and the cover
sections.
Connect your machine to the mains supply; it is now ready.
Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
13
English