Publicité
Les langues disponibles
Les langues disponibles
HID207
User Manual
Specifications
The ice maker-dispenser is designed to be installed
indoors, in a controlled environment. Although
it can operate in a wide range of air and water
temperatures, it will provide the best performance if
not subject to extremes.
Air Temperature Limitations
• Maximum: 100
F. or 38
o
• Minimum: 50
F. or 10
o
Water Temperature Limitations
• Maximum: 100
F. or 38
o
• Minimum: 40
F. or 4.4
o
Water Pressure, potable
• Maximum: 80 PSI or 5.5 Bar
• Minimum: 20 PSI or 1.3 Bar
Water Conductivity:
• Minimum: 10 microSiemens/cm
RO water may be supplied to the potable water
system, but if it has less than the above conductivity,
the water level sensor will not detect water and the
unit will not make ice.
Deionized water will not work and isn't recommended.
Voltage - 60 Hz
• Maximum: 126
Minimum: 104
Operating the machine outside of any of the above
limitations is considered abuse and any resulting
damage is not covered by warranty and could cause a
complete loss of warranty coverage.
Warranty Information
The warranty statement for this product is provided
separately from this manual. Refer to it for applicable
coverage. In general, warranty covers defects
in material or workmanship. It does not cover
maintenance, corrections to installations, or situations
when the machine is operated in circumstances that
exceed the limitations printed above.
C.
o
C.
o
C.
o
C.
o
This is a commercial model, if installed in a residence
some commercial service companies may not be able
to service it on site.
Product Information
The product is an ice maker-dispenser. It is designed
to be installed on a countertop or on a specific
machine stand.
• All models require a drain. An internal drain basin
separates the ice storage bin's drain from the drip tray
drain.
• A backflow preventer may be required by local
plumbing codes, although backflow is prevented by
the included float and reservoir design.
• It is equipped with a 6 ft. power cord with NEMA
5-15P plug.
• Air flow is left to right and there is a cleanable air
filter included.
• 4" or 10 cm legs are optional for counter models.
Thread size 3/8 - 16.
• Ice or water vending is triggered by touch free
sensors or buttons, depending upon the model.
• For available options and kits, see sales literature.
Scotsman Ice Systems are designed and
manufactured with the highest regard for safety and
performance.
Scotsman assumes no liability or responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the use
of any part and/or other components not specifically
approved by Scotsman.
Scotsman reserves the right to make design changes
and/or improvements at any time. Specifications and
design are subject to change without notice.
March 2024
Page 2
Publicité
