Publicité
Les langues disponibles
Les langues disponibles
HID207
User Manual
Ice Making and Ice Dispensing System Cleaning Instructions Cont'd
13. This is a greaseless bearing. Black oxidation may
be present which is normal; check for any and
wipe way. Inspect the bearing seal for wear and
rust. Call for service if any is found.
14. Wash the ice sweep and lower part of the breaker
with the scale remover solution. Remove as much
scale as possible.
Bearing
Moving parts hazard.
Risk of personal injury.
Caution: Be SURE no scale remover contacts the
bearing.
15. Return the ice sweep to its original position.
16. Press and release the Clean button. The Time to
Clean light will blink on and off.
17. After 40 minutes (20 of no ice making and 20
making ice) the ice machine will shut off and the
control panel will show 0.
18. After ice making starts, continuously add scale
Ice
remover solution to the reservoir to keep it about
Sweep
half full.
19. When all remaining solution is used, rotate
the float valve knob to the ON position. Ice will
continue to be made.
20. Rotate float valve lever to Off and pull the drain
plug again to drain the system, then replace it.
21. Pour a gallon of hot (95
ice storage bin to flush out the drain and melt all
ice that was made during the cleaning process. Be
sure all ice is melted.
Note: Only add 16 oz or 1/2 liter water to the bin at a
time, as excess water will drain out the spout.
22. Rotate float valve knob to the ON position.
Breaker
23. Push and release the On button to restart ice
making.
24. Operate the machine for 15 minutes and then
pour water onto the ice in the bin until it has all
been melted.
Note: Only add 16 oz or 1/2 liter water to the bin at a
time, as excess water will drain out the spout.
25. Rotate the float valve knob to the off position.
26. Locate reservoir drain and pull its drain plug out to
drain the reservoir and evaporator. When draining
is complete, return the plug to its original position.
27. Rotate the float valve to the ON position and allow
the reservoir to fill up with water. Cleaning out any
traces left of scale remover.
28. Once the reservoir is full, rotate the float valve to
the off position and pull its drain plug out to drain
the reservoir and evaporator. When draining is
complete, return the plug to its original position.
29. To continue, see the Sanitizing section for next
steps.
March 2024
Page 19
F. – 115
F.) water into the
o
o
Publicité
