Publicité
Les langues disponibles
Les langues disponibles
HID207
User Manual
Maintenance and Cleaning - Dispensing Bin Components
The ice storage bin and rotor must be cleaned and
sanitized on a regular basis, at a minimum when the
ice making system is cleaned. Hand tools and hand
protection like rubber gloves are recommended for
this procedure.
Note: Some steps overlap with the procedure on the
next page. This procedure can be independent of the
ice making system cleaning or can be part of it.
Bin Cleaning Procedure
1. Vend or melt out all ice.
2. Unplug from electrical power.
3. Remove top panel
4. Remove splash panel.
Moving parts hazard.
Risk of personal injury.
Disconnect electrical
power before
proceeding.
5. Disconnect ice level control at harness.
6. Remove phillips head screws holding ice storage
bin cover to ice storage bin, set aside.
7. Remove ice storage bin cover, set aside.
8. Remove bolt securing agitator bar and agitator
bar, set aside.
9. Lift up and remove dispense rotor, set aside.
Note: Slowly add only 16 oz or 1/2 liter water to the
bin at a time, as excess water will drain out the spout.
10. Mix a solution of ice machine scale remover, such
as Scotsman Clear 1 and potable water per the
directions supplied with the scale remover.
11. Use a clean cloth and wash all the interior
surfaces of the bin and the bin cover, agitator
bar, chute cover and dispense rotor with the ice
machine scale remover solution. Rinse with clear
water.
Dispense
Rotor
12. Mix a 2 gallon or 7.5 liter solution of locally
approved sanitizer. A possible sanitizer solution
could be a mixture of 4 oz/118ml of locally
approved sanitizer and 2.5 gallons of warm
(90
F/32
C to 110
0
0
13. Use a new clean cloth and wash all the interior
surfaces of the bin and the bin cover, agitator bar,
and dispense rotor with the sanitizer solution.
14. See page 20 to continue with cleaning steps.
March 2024
Page 17
Agitator Bar
F/43
C) potable water.
0
0
Publicité
