Publicité
Les langues disponibles
Les langues disponibles
HID207
User Manual
Ice level controls
Clean if the controller indicates bin full and there
is no ice between the sensors.
1. Shut machine off.
2. Remove top panel.
3. Remove splash panel.
4. Disconnect ice level controls at connector.
5. Remove 15 phillips head screws and ice storage
bin cover.
6. Pull each sensor grommet clip up and off.
7. Push grommets out of bin top.
8. Pull each sensor out of its rubber grommet. Pull
on the part closest to the grommet, not the wire.
9. Wipe the sensor lenses clean with a soft, clean
cloth. Caution - do not scratch the lens. If there
is mineral scale on the lens, ice machine scale
remover will be needed to wipe them clean.
Sensor Grommet Clips
10. Return each sensor to a grommet, push it in until
it snaps into place.
11. Reverse the rest of the steps to reassemble.
March 2024
Page 16
Publicité
