Publicité
Les langues disponibles
Les langues disponibles
HID207
User Manual
Initial Start Up
1. Remove panels: top and left side.
2. Turn water on, observe that water enters the water
reservoir, fills and then shuts off. Check for leaks.
Repair any leaks before going any further.
3. Plug in ice machine into it's own circuit; with no
other appliances. On the Indicator Light Panel the
Power light will show green.
4. Locate the External Button on the Splash Panel
and hold down for 3 seconds. Then on the
Indicator Light Panel, the Status light will show
green and the ice making process will start. Warm
air will blow out the right side.
Note: If the ice making process doesn't start, remove
the right side panel, remove the Control Box cover
and check for any errors being displayed. See page
15 for details..
5. Within minutes ice will begin to fall into the
dispensing bin. Check ice dispensing by holding
a container in front of the Touch Free ice sensor
(just below the ice delivery spout) or push the ice
vend button on model HID207ABX. The ice will
dispense and ice should flow from the spout when
a container is present, and stop dispensing when
the container is removed.
6. Check water dispensing by holding a container
in front of the Touch Free water sensor or push
the water dispense button on model HID207ABX.
Water will flow when a container is present, or
but when button is pushed, and stop when it is
removed, or button let go.
7. Press and hold the External Button for 3 seconds
to stop the ice making process.
POWER
STATUS
BIN FULL
March 2024
Page 9
8. Wait about a minute for the ice making process to
finish, then unplug or disconnect electrical power.
9. Remove bin insulation and cover. Scoop out any
ice in the bin and sanitize the interior of the ice
storage bin by wiping it with a locally approved
sanitizer or a mixture of 2 oz of locally approved
sanitizer and 1.25 gal of 95-115 degrees water,
allow to air dry.
10. Replace all covers and panels.
11. Reconnect electrical power.
12. Press and hold the External Button for 3 seconds
to start the ice making process.
13. Give the owner/user the user manual, instruct
him/her in the operation and maintenance
requirements of the unit. Make sure they know
who to call for service.
14. Have the customer fill out the Customer
Evaluation and Warranty Registration form,
and mail it in to Scotsman or register the unit at
Scotsman's website (www.scotsman-ice.com) or
scan the QR code behind Drip Tray.
UV
External
Button
CLEAN
Publicité
