Denver E-8600 RM H700 Manuel De L'utilisateur page 66

Torque signal
"25"
error
The torque
sensor speed
"26"
signal has a
fault
Overcurrent In
"27"
the regulator.
Communication
" 30"
problem
The brake signal
has a fault (if
"33"
they are brake
sensors
mounted)
The sensing
"35"
circuit for 15V
it has a fault .
The detection
circuit on the
"36"
keyboard has a
fault .
6. Change the speed sensor to see if the problem
solves. If the problem persists, replace the regulator
or contact the supplier .
1. Check that all the connections they are correct -
mind executed .
2. Connect the Pedelec to the BESST system to see
if this can read the couple .
3. Using the BESST tool , update the reg-
olator to see if the problem is solved , if necessary
otherwise replace the torque sensor or contact your
supplier .
1. Check that all the connections are well executed
2. Connect the Pedelec to the BESST system to see
if this can read the speed sign .
3. Change the dial to fix the problem .
4. Using the BESST tool , update the regulator to see
if the problem solves it , in case opposite replace the
torque sensor or contact yours supplier .
Using the BESST tool , update The regulator . If the
problem persists , changes The regulator or contact
The your supplier .
1. Check that all the Pedelec connections they are
correctly executed .
2. Using the BESST tool , run a diagnostic test to try
to pinpoint the problem .
3. Change the view to see if the problem was solved
4. Change the EB-BUS cable to see if the problem
solves .
5. Using the BESST tool, update the controller
software again . If the problem persists , change the
controller or contact your supplier .
1. Check that all the terminals they are connected to
the brakes correctly .
2. Change i brakes to see if the problem was solved
3. If the problem persists , change the regulator or
contact the supplier .
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite ,
change the regulator or contact yours supplier .
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite ,
change the regulator or contact yours supplier .
66