Publicité
Les langues disponibles
Les langues disponibles
WARNINGS: Always remove the battery before performing any maintenance.
Cleaning
In order to avoid corrosion on the bicycle, it should be rinsed in fresh water after every use, especially
if it has been exposed to sea air.
It should be cleaned with a sponge, a bowl of warm soapy water and a hosepipe (without pressure).
RECOMMENDATION: Be particularly careful to not use a pressurised water jet.
Lubrification
Lubrification is essential for the various components that move, in order to avoid corrosion. Regularly
grease the chain, brush the sprockets and chain rings and trickle a few drops of lubricant into the brake
and derailleur cable sheaths.
We recommend starting by cleaning and drying the components to be greased.
Specific lubricant is recommended for the chain and derailleur. Grease can be used for the other
components.
Regular checks
Concerning the tightening of the bolts: lever, crank, pedals, brackets.
The tightening torques to apply are as follows:
COMPONENTS
Pedals on crank arms
Crank arm on bracket
Stem/handlebar tightening
Headset tightening
Brake lever
Brake callipers
Seat
Seat post clamp
Wheel
The other tightening torques depend on the nut sizes: M4: 2.5 to 4.0 N.m., M5: 4.0 to 6.0 N.m., M6:
6.0 to 7.5 Nm. Tighten the bolts according to the required torque.
Regularly check the tyres and the tread of the rear wheel: wear, cuts, cracks, pinching. Replace the tyre
if necessary. Check the wheel rims for excessive wear, warping, denting, cracks...
RECOMMENDED TORQUE
(Nm)
30 - 40
30 - 40
9 - 10
14 - 15
14 - 15
6 - 8
6 - 8
18 - 20
30
53
SPECIFIC GUIDELINES
Lubricate the threads
Lubricate the threads
Immersion screw (stem)
Quick clamp
Publicité
