Denver E-8600 RM H700 Manuel De L'utilisateur page 67

The WDT circuit
"37"
is defective .
The tension
total from the
"41"
drums
it's too much
high.
The tension
total from the
"42"
drums
it's too much
low.
The power total
from the cells
"43"
from the
battery is too
much high.
The tension
from the single
"44"
cell is
too high.
The
temperature
"45"
from the
battery is
too high.
The
temperature
"46"
from the
battery is
too low.
The SOC of
"47"
battery is too
high.
The SOC of
"48"
battery is too
low.
Detection fault
"61"
from the
switching.
The derailleur
"62"
electronic
unlock
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite,
change the regulator or contact yours supplier .
Replace the battery.
Recharge the battery. If the problem persists
replace the battery.
Replace the battery.
Replace the battery.
Let the pedelec cool down.
If the problem persists, replace the battery.
Bring the battery up to temperature environment. If
the problem persists, replace the battery.
Replace the battery.
Replace the battery.
1. Check that the gear lever is not blocked.
2. Replace the gear lever.
Replace the derailleur.
67