Denver E-8600 RM H700 Manuel De L'utilisateur page 64

Error Codes
Press (<0.5S) the button
For confirm . Now press (<0.5S) the button
They will come show yourself The last ten error codes of the Pedelecs. The error code " 00" means
which isn't there no error.
Press (<0.5S) the button
ERROR CODE DEFINITION
Code
Broken down to
the accelerator
"04"
The accelerator
did not return
"05"
in the position
Overvoltage
"07"
protection
Mistake signal
"08"
Hall sensor
or to highlight " Error code", then press (<0.5S) the button
to exit and return to the "Information" screen.
Cause
1. Check That the terminal and the cable of the
accelerator
are not damaged and are connected correctly .
2. Unplug and replug the accelerator , if not yet
it works , replace the accelerator .
Verify that the terminal of the accelerator is
connected
correctly. If this doesn't solve the problem,
correct
change the accelerator.
1. Remove and reinsert the battery to test solve the
problem.
2. Using the BESST tool, update the regulator.
3. Replace the battery to solve the problem.
1. Check that all the engine terminals they are
connected correctly.
2. If the problem persists, replace the motor.
or to view a list of error codes.
Possible Solution
64