JAC VARIA Mode D'emploi page 16

D. If the blade needs to be replaced, do so in accordance with the blade replacement procedure
(fig.7).
E. Clean with a brush and vacuum the inside of the machine.
Be sure to check that your approved agent has recorded his work in your service booklet in order to
maintain your 5-year warranty cover.
8.3 Blade replacement, by an approved agent
The red blade replacement symbol (fig. 9, n°68) indicates need for blade replacement.
(fig.7)
Be sure to wear cut-resistant gloves (Standard EN 388: 2003 factor B= 5) and safety footwear always
when replacing a blade or when working in the vicinity of the blades.
Having ensured that the plug on the machine (fig.2, n°12) has actually been disconnected from the mains:
Open the door (fig.1, n°10) using the lock (fig.1, n°9).
Remove the crumb tray (fig.1, n°8).
Replace the blade:
A. Unscrew the two spanners located on the left-hand side of the machine (fig.7, n°23).
B. Remove the blade guard (fig.1, n°6) by means of the Allen screws.
C. Unscrew the nut that secures the blade (fig.7, n°24) using the two spanners supplied (fig.7,
n°23).
D. Remove the spacer and replace the blade, taking care to position it correctly on the locator
pins. Replace the spacer.
E. Fit and tighten the new nut supplied with the new blade to lock the blade, using the spanners
supplied. It is important that the new nut be fitted in order to ensure optimum tightening.
Refit the crumb tray and close the door.
Connect the machine to the mains supply, it is now ready.
Be sure to check that your approved agent has recorded his work in your service booklet in order to
maintain your 5-year warranty cover.
Please note that your blade can be sharpened; contact your approved agent for further information.
To make the machine safe during each intervention, make sure, before starting the intervention, to:
- Open the cover of the machine
- Switch off the machine
- Disconnect the power supply
- Place the electrical plug on the cutting table and close the cover on the cable to prevent
reconnection to the electrical supply during the operation
- Do not disconnect the ground wires.
After any intervention, ensure that the machine can be used in complete safety by:
- Checking that the door is locked (fig.1, n°9)
- Checking the locking of the cover (adjust the position of the cover lock (fig.6, n°21) if the
intervention carried out has impacted its position)
- Locking the wheels fitted with a brake (fig.1, n°7) after having put the machine back in place
(make sure that the main switch is accessible)
- Check the connection of the ground wires.
English
16