JAC VARIA Mode D'emploi page 10

5 INSTALLATION AND COMMISSIONING
5.1 Unpacking the machine
Machines are delivered from our works on pallets, strapped, under a plastic cover and protected with
cardboard. First of all, the packaging must be examined and any damage caused in transit must be
declared directly to the carrier.
A. Remove the cardboard and the packaging bag from the machine.
B. Remove straps, taking particular care when they are released by cutting.
C. Detach the machine from its pallet by removing the wooden battens wedging the castors.
D. Take the machine off the pallet. Make sure you do this with at least two people in order to lower
it as gently as possible onto the floor. We strongly advise using an unloading ramp,
After unpacking the machine, check that it has not been damaged in transit.
Notify immediately any discrepancy by mentioning it on the carrier's delivery note.
5.2 Location
To achieve excellent performance and long-term reliability, choose a location that is:
Well ventilated, shielded from direct sunlight and away from sources of heat, with a flat and sturdy
surface free from vibration.
Ensure that the main switch is accessible after installation to ensure easy unplugging in case of
emergency or similar reason.
5.3 Electrical connection
IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
The supply circuit of the machine must not be used to supply other equipment.
The circuit breaker (CB) of the machine supply circuit, must be installed as indicated below:
- North America: 15 A Curve D protection;
- Rest of the world: 16A Curve D protection.
The Residual Current Device (RCD) of the machine supply circuit, must be installed as indicated
below:
- 300 mA RCD.
English
10