JAC VARIA Mode D'emploi page 11

Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting the machine to the mains supply and in order to prevent the motor from burning out
when it is switched on, it is important to check that the mains supply matches the machine specification
(see machine nameplate).
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates an electrocution hazard. Please isolate the machine before
carrying out any work on it. You will find this pictogram at the back of the machine
close to the power cable and inside the machine on the electrical enclosure (fig.8,
n°25).
You will find the circuit diagram for the machine on the back of the electrical
enclosure door (fig.8, n°26).
5.4 Commissioning
Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
For machine operation, please refer to the "Operation" chapter.
5.5 Hazard
If the user or the machine is in danger, use the main isolator switch to cut the power supply to the machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Wear gloves for any maintenance or cleaning work by the blade.
To replace the blade, have the work done by your approved dealer.
Always wear cut-resistant gloves when replacing the blade or when working in the vicinity of the blade.
Any work involving maintenance or replacement of parts must be carried out by a qualified individual.
11
English