Publicité
Les langues disponibles
Les langues disponibles
BBC 34WS-6, 34WS-8
Problem
Cause
Excessive wear of the piston tip
Spline breakage
Lack of lubrication
Dirt intrusion (specially when drilling
upwards)
Piston breakage
Lack of lubrication
Uneven tension in the side bolts
Worn intermediate part/piston guide (can
be confirmed by the cushion test)
Side bolt breakage
Uneven tension on the bolts
1
Gauge for chuck bushing 22 mm (
2
Use Atlas Copco no. 9090 0550 80 pressure gauge to test the water and air pressure.
Machine data
Technical data
Part number
Air consumption at 6 bar
Piston bore
Stroke length
Impact rate at 6 bar
Overall length
Weight
Hole diameters
Feed length
Chuck, hexagon shank
Noise and vibration declaration statement
Guaranteed sound power level Lw according to ISO 3744 in accordance with directive 2000/14/EC.
Sound pressure level Lp according to ISO 11203.
Vibration value A and uncertainty B determined according to ISO 5349-2. See table "Noise and vibration data"
for the values of A, B, etc.
These declared values were obtained by laboratory type testing in accordance with the stated directive or
standards and are suitable for comparison with the declared values of other tools tested in accordance with
the same directive or standards. These declared values are not suitable for use in risk assessments and values
measured in individual work places may be higher. The actual exposure values and risk of harm experienced
by an individual user are unique and depend upon the way the user works, in what material the machine is
used, as well as upon the exposure time and the physical condition of the user, and the condition of the machine.
We, Atlas Copco Construction Tools AB, cannot be held liable for the consequences of using the declared
values, instead of values reflecting the actual exposure, in an individual risk assessment in a work place situation
over which we have no control.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed. An EU guide to managing
hand-arm vibration can be found at http://www.humanvibration.com/EU/VIBGUIDE.htm
We recommend a programme of health surveillance to detect early symptoms which may relate to vibration
exposure, so that management procedures can be modified to help prevent future impairment.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0829 71a | 2010-01-01
Original instructions
7
⁄
") hexagon shank Atlas Copco no. 3091 0038 00.
8
BBC 34WS-6
8311 0104 03
125
l
⁄
s
80 mm
70 mm
37 Hz
1610 mm
43.5 kg
27–41 mm
770 mm
22 x 108 mm
Safety and operating instructions
Solution
Change piston
2
Lower the water pressure
if it is the same as or greater than the
air pressure
Increase lubrication or change oil
Increase regularity of servicing
Lower the water pressure if it is the same as or greater than the air
pressure
Increase lubrication or change oil
Tighten the bolts correctly
Change the worn part
Tighten the bolts correctly
BBC 34WS-8
8311 0104 04
125
l
⁄
s
80 mm
70 mm
37 Hz
1810 mm
45 kg
27–41 mm
970 mm
22 x 108 mm
23
Publicité
