Pelgrim IK8093R Serie Mode D'emploi page 59

TROUBLESHOOTING
Symptom
The controls respond poorly.
The display shows
Er03.
The display shows code E2.
The display shows code E8.
The display shows code U400. Check the connection; the
The display shows code EC
(Er63) or EC (Er64).
The display shows code E6-3,
E6-6, or Er45-9.
In case of other problems, contact the service department.
Possible cause
There may be a thin layer
of water on the hob or on a
finger, causing the controls to
respond poorly.
There is an object or water on
or code
the control panel.
Excessive hob temperature.
Fan air intake is blocked/Fan
defective.
appliance is connected
incorrectly.
There is a problem with
the mains power. Faulty
connection.
Solution
Make sure the hob and/or
finger is clean.
Remove the object; clean the
control panel.
Let the appliance cool down.
Then switch the hob on again.
Remove the obstruction/
Replace the fan.
Disconnect power to the
appliance and check the
mains voltage.
Switch off the cooking zone,
remove all pans from the hob,
andallow the appliance to cool
down. Then switch the hob on
again.
Check the connection and
interconnections on the
appliance.
EN 29