Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Menu item (A)
U6: permanent pan detection 0: permanent pan detection not active
U7: timer sound signal
U8: power limiter
These settings apply for a
single-phase connection!
1. Touch the menu button for 3 seconds.
The menu item and its corresponding value are shown on the displays of the two right-
▷
hand cooking zones.
2. Touch the top slide control to select another menu item.
The left part decreases the value, and the right part increases the value.
▷
3. Touch the lower slide control to select a different value.
The left part decreases the value, and the right part increases the value.
▷
4. Touch the on/off button for 3 seconds to confirm the settings.
5. Touch the menu button for 1 second to exit the menu.
Service menu
The service menu is intended exclusively for an authorized, qualified installer.
Open the service menu within 2 minutes after connecting to the mains.
1. Touch the flashing menu button.
2. Touch the on/off button 3 times within 1 second.
Each valid touch of a button is confirmed by a sound signal.
▷
3. Then touch the on/off button for 5 seconds.
If the entry is successful, the service menu item (A) and its corresponding value (B)
▷
appear on the displays of the two right-hand cooking zones.
▷
If a wrong button is touched, input is not possible again until all buttons are released.
EN 24
Values (B)
1: permanent pan detection active
0: timer sound signal for 120 seconds
1: timer sound signal for 20 seconds
2: timer sound signal one time only
--: no power limitation
2.0: power limited to 2.0 kW
2.1: power limited to 2.1 kW
...
10: power limited to 10 kW
Factory default
values
1
0
--
Publicité
