SURE petcare SURE FLAP pet door CONNECT Guide D'utilisation page 27

14
15
16
17
18
19
20
Once you've marked the screw holes, remove the Pet Door from the wall
and place it away from the work area. Drill the 4 holes in the wall using
an appropriate drill bit, being careful not to break through the edge of
the main hole. Once drilled put the wall plugs into each of the holes.
Replace the Pet Door, with its extended tunnel, back
into the hole. Then, using the appropriate screws for
your wall plugs, screw the Pet Door to the wall - see
the diagram on the left. You can then replace the
front of the Pet Door as it is safely secured to the
inside of your wall.
Now you can move to the outside of the house. The extended tunnel of
the Pet Door should now be poking out of the hole. Place the external
frame over the tunnel.
Using a sharp pencil or pen, mark the position of the 4 screw holes
required to mount the external frame.
Briefly remove the frame and drill the 4 holes
into the wall using the appropriate drill bit for
the material. Then replace the external frame
and, using the appropriate screws for your wall
plugs, screw it into position.
Now, insert the 4 screw caps,
noting that the groove needs to be
facing away from the tunnel.
Lastly, use an All-Weather sealant to seal the gap between the tunnel
and the external frame. We also recommend putting some sealant
around the join between the external frame and the wall.
EN
26