SURE petcare SURE FLAP pet door CONNECT Guide D'utilisation page 19

5
Once the main hole is cut, check whether there is any metal within your door. If you
can see metal, go to page 21 and follow the instructions for fitting in a metal door.
6
7
8
1
9 4
10
Using a jigsaw, cut around the outer edge of the line you have
marked. By doing this, the Pet Door should fit through the hole
first time. However, if you cut on, or inside the line, the hole is
likely to be too small. If this is the case, please take the time to
carefully file the hole until the Pet Door fits through easily.
Now put the tunnel of the Pet Door through the hole.
Remember the SureFlap logo and LCD display must be inside
the house. We advise that you have two people for this, one
inside the house and one outside to help hold the product
firmly in place.
On the outside of the house, make sure the tunnel of the Pet
Door is securely pushed through the hole and then slide the
external frame over it. When the external frame is in place,
using a sharp pencil mark through the four holes.
Remove the Pet Door from the hole and drill the four screw
holes using a 6mm drill bit (1/ 4 inch). We now recommend
you choose the correct length of screw out of those provided
to attach the Pet Door to the door. Do this by measuring the
length of the screw against the depth of your door. The screw
must be roughly 15mm (5/ 8 inch) longer than the depth of your
door so it can hold the Pet Door in place.
Put the Pet Door back through the hole, position it centrally
3
and replace the external frame. Then, using a cross head
screwdriver and the screws you selected, attach the external
frame. Fasten the first screw until it is secure, but not too
2
tight, then do the same with the remaining three. Once all four
screws are secure, tighten them, but alternate between screws
as you go to ensure the product is tightened evenly.
Now, insert the four screw caps,
noting that the groove needs to be
facing away from the tunnel.
EN
18