SURE petcare SURE FLAP pet door CONNECT Guide D'utilisation page 20

Fitting your Pet Door in glass
Tools and supplies required
Ruler
Glazier
Step-by-step guide for cutting the hole in glass
Please contact a qualified glazier or Pet Door installer to discuss your specific glass
fitting requirements. Fitting into double or triple glazing will require a new pre-cut
pane to be purchased, cut and fitted following the steps below.
To fit your Pet Door into glass, you will require a circular hole
to be cut measuring 300 mm or 114/ 5 inches in diameter.
This will need to be done by a professional glazier.
To ensure your pets have unhindered access through the Pet
Door, you will need to make sure that this circular hole is cut
at the appropriate height. Do this by first measuring the height
of your pet's tummy from the floor.
Take this height and add 120mm to it (43/ 4 inches), this will give
you the total distance from the floor to the centre of the circle
you need cutting. Make sure this point is at least 200mm or 8
inches from the bottom of the window frame to allow room for
the mounting adaptor.
Pet's tummy height + 120mm = the centre of the circle.
If you are fitting in a double or triple glazed unit, ensure the
glazier uses a non-metallic spacer bar around the hole to seal
the layers of glass. A metal spacer could compromise the Pet
Door's ability to read microchips.
Have you programmed all of your pets into the Pet Door? If not, we advise you do this
prior to fitting. See page 13.
19
Cross head screwdriver
Clear all-weather sealant
surepetcare.com/support/microchip-pet-door-connect
accessory
SureFlap Pet Door mounting adaptor
The screws and screw caps provided
X
300 mm