Fulgor Milano F7SRC36S1 Notice D'installation page 39

7.3 Mounting the handles
on cladded models
To mount the handles onto the door and
the drawer operate as follows:
Operate as follows:
> Insert the handle ends onto the supports
already installed on the door and the drawer
1
> Screw in the set screws available on the handle
2
The screws must be tightened in by means of a
2.5 mm (1/8") hex key or driver. It is recommen-
ded to use a thread-locking compound on the set
screws to ensure they do not loosen over time /
use.
7.4 Post installation checklist
Check that the front levelling feet have been
properly installed.
Check that the connection to the water system
does not have any leaks and that the shut-off valve
is easily accessible.
Check that the electrical connection is correctly
installed and that the socket and / or breaker are
easily accessible.
Check the perfect alignment of the appliance
with adjacent structures.
Check that all adhesive tape and external or
internal temporary protective devices have been
removed.
Check the perfect closing of the doors and the
[ 1 ].
smooth sliding of the drawers and shelves.
7.5 Start up
>To turn on all the appliance compartments,
press the Unit
display will show the message "Initial test" for
approximately 2 minutes. After this phase the
compressors will start up and remain on until
the compartment set temperatures are achieved.
Serigra a VETRO USER 599 LCD2.8
> If the appliance is provided with an Ice Maker,
[ 2 ].
prior to switching it on make sure that the water
filter cartridge is installed (unless water supply
source is already filtered by other means such as
reverse osmosis).
>
Purge air from the water lines by performing
Testo e gra ca
the 'Manual Clean'. You may need to complete this
sequence several times until you stop hearing air
sputtering from the ice maker fill tube (Refer to
your Use & Care Manual).
>
Once you are satisfied that the system is purged
of air switch the Ice Maker on in the ice maker
Limite per gra ca parti retro-illuminate - la parte bianca è trasparente
menu item ICE MAKER
refer to the Use & Care Manual for more details.
> For further information about the appliance
operation, refer to the User Manual.
If at the first start messages appear, such
as Fridge too warm, Freezer too warm,
or sound signals are activated, it means
that the appliance has already previously
started the cooling process.
If this is the case, deactivate any possible
acoustic signals by pressing the Alarm
button for three seconds. The
00
Funzioni
+ °C
00
+ °C
Impostazioni
00
- °C
of the appliance functions. Please WATER FILTER
SYSTEM CLEANING
EN
Co
co
39