Fulgor Milano F7SRC36S1 Notice D'installation page 29

> Hook the bottom drawer panel starting from the
adjustment bolts on the bottom
2
> It is now possible to align panels to adjacent
cabinets in height using the lower alignment
bolts and brackets, [ 3 ]
ning the screws into position as needed. With the
screw slighty tightened, move the panel sideways
manually to align it to the other panels on the unit
or other adjacent structures.
Set the bottom adjustment bolts using the lock
nut against the bottom of the drawer once you
are satisfied with the height alignment.
3
> Depth alignment: working from the inside of
the drawer, after lifting up the magnetic seal or
rotating the cover plate where necessary, adjust
the panel position in the Z-direction by adjusting
the shoulder bolts and setscrews with the 4mm
hex key in conjunction with each other finally
locking each mounting position in place
[ 2 ].
tightening or untighte-
[ 4 & 5 ].
4
5
EN
29