Fulgor Milano F7SRC36S1 Notice D'installation page 21

> Prepare the appliance door for panel mounting by threading the shoulder bolts into the recessed
receivers and the set screws into the other hole
into the door and not on the visible end. Thread this in far enough that it is flush with appliance door face
so as not to interferece with hanging the panel. You will adjust these later.
7
[ 7 ]. Ensure the end with the hex key socket is threaded
Shoulder bolt for hanging brackets on and
for pulling panel in towards the appliance
door.
Set screw used to set depth / z-axis
position of panel and to put opposing
pressure at each fixing point to 'lock'
panel in place.
EN
21