Fulgor Milano F7SRC36S1 Notice D'installation page 16

3. PREPARING THE INSTALLATION
EN
3.1 Transport to installation site
and unpacking
The appliance is very heavy.
Take maximum care during handling
to avoid injury.
The appliance should always be
transported in an erect position.
Avoid at all costs leaning it on its front
side.
2
1
3
Since this is a large and heavy appliance, before
transporting the appliance, check the access to
the location where it will be installed (door size,
maneuvering space in stairwells, etc.).
The appliance is attached to the base of the packaging
(pallet) through four bolts which can be removed
using a 19 mm (3/4") wrench.
It is recommended to use a manual transporting device
to move the appliance to the installation site, and only
at this point to remove the base of the packaging.
The appliance should always be transported in an
erect position.
If this is not possible, transport the appliance laying
on its rear side.
Once at the installation site, the appliance, which is
equipped with four wheels, can be taken off the pallet
and positioned in the installation area.
Operate as follows:
> Take off the four bolts securing
to the pallet by means of a 19 mm (3/4") wrench or
socket.
> Remove the fixing brackets
> To release the front fixing bracket
rear wheel adjusting bolt
(1/2") wrench or socket. Avoid straining this bolt at its
stop points one way or the other so as to not damage
16
4
1
[ 1 ] the appliance
[ 3 ] and [ 4 ] .
[ 3 ] , loosen the
[ 2 ] by means of a 13 mm
the rear leveling system.
Ensure the front leveling legs are retracted so that
all 4 wheels are able to contact the floor for easiest
maneuvering.
> From the back or side of the unit and by means of a
suitable, heavy duty hand trolley, take off the appliance
and place it on the floor.
Be very careful to avoid any damage to floors. Delicate
floors should be protected with plywood, hard
cardboard or similar material panels.
3.2 Electrical and water connection
The Built-in filter cannot make it safe
to drink any water which is not already
suitable for human consumption.
The appliance should be connected only
to a potable water supply system.
Do not use extension cords or adapters.
Once the appliance is fully installed,
connected to
applicable) and operational, in the event
that the water supply must be turned off,
(touch the button
disable the ice maker) before the main
water is shut off to prevent the appliance
from entering a 'NO WATER IN' alarm
state.
• OVERHEAD VIEW •
E W
E W E
W
ELECTICAL & WATER
CONNECTION
W E
Electrical or water connections located
directly behind the appliance must be
recessed. Do not put the water shut-off
valve directly behind the appliance.
It should be in an accessible location.
the water supply
on control panel to
ICE MAKER WATER FILTER
SYSTEM CLEANING
E W E W
E
W
E E W
W
W E
(if