Publicité
5
1
3
2
6
16
4
5
7
3
5
2
6
1
2.3
Fitting the bead breaker
Fig. 5 Fitting the bead breaker
1 Bead breaker
2 Hook
3 Spring
4 Bead breaker support
5 Holes in bead breaker and support
6 Pin
7 Self-locking hub nut
• Place the bead breaker (1, Fig. 5) inside the support
(4). The holes (5) in the bead breaker and support
must line up.
• Lightly grease the pin (6). Fix the bead breaker in
the support with the pin (6) and hub nut (7).
• Attach the spring (3) to the hook on the frame and
connect it to the hook (2) on the bead breaker.
2.4
Mounting the pressure gauge holder
and connecting the pedal controlled
inflating device
Fig. 6 Pressure gauge holder with tool box
1 Pressure gauge holder
2 Cabinet (left rear corner)
3 Screw
• Fix the pressure gauge holder (1, Fig. 6) on the
cabinet (2, Fig. 6) with the two screws (3, Fig. 6).
• Pass the pressure gauge hose through a hole in
the rear panel of the cabinet and connect it to the
quick inflation valve (see also Fig. 2).
For details, consult the pneumatic diagram shown in
the spare parts list.
Publicité
