Télécharger Imprimer la page

Tunturi 17TSHG6000 Manuel De L'utilisateur page 22

Masquer les pouces Voir aussi pour 17TSHG6000:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
English
⚠ WARNING
• When using the latissimus grip, first the load must be selected,
before the grip is mounted.
• If you change the weight in the meantime you have to hold the
upper weight to prevent the grip falling down.
Warning:
Before beginning any exercise program, consult your physician. This
is especially important for individuals over the age of 35 or persons
with pre-existing health problems.
Read all instructions before using any fitness equipment.
Tunturi New fitness bv. assumes no responsibility for personal injury
or property damage sustained by or through the use of this product.
Save these instructions!
Important assembly information
Before you start
We recommend to use two adjustable wrenches to assemble your
product. If you have metric sized wrenches in correct size this is fine
too.
‼ NOTE
• Suitable (adjustable) wrenches are "NOT" provided with the
product, neither included in the assembly kit.
• It is strongly recommended that this equipment is assembled by
two or more people to avoid possible injury.
Description illustration A
The illustration shows what the trainer will looks like after the
assembly is completed.
You can use this as a reference during your assembly, but do follow
the assembly steps always in the correct sequence as showed in the
illustrations.
Description illustration B
The illustration shows what components and parts you should find
when un-boxing your product.
‼ NOTE
• Small parts can be hidden/ packed in hollow spaces in the
Styrofoam product protection
• If a part is missing, contact your dealer.
Description illustration C
The illustration shows the hardware kit that comes with your product.
The hardware kit contains bolts, washers, screws , nuts etc. and the
required tools to properly fit your trainer.
Description illustration D
The illustrations shows you in the correct following order how to
assembly your trainer best.
‼ NOTE
• Part numbers shown in the assembly steps are commencing
with the spare part drawing that can be found in the online full
version user manual.
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to prevent damage to
the floor surface.
• Allow at least 60 cm of clearance around the equipment.
• Refer to the illustrations for the correct assembly of the
equipment.
Additional assembly information
Weight plate installation
Slide weight plates onto Guide Rod from
top to bottom.
The deep groove on each weight plate
needs to face front and downwards.
Deep Groove
Cable installation
Before installing the cables it is
⚠ important:
- To de-tangle the cables fully.
- To avoid the cable from twisting during transiting over the pulley
wheels.
⚠ WARNING
• A twisted cable in the installation can result in separating the
outer protective plastic coating from the inner steel cable.
• A twisted cable in the installation can result in the cables to
entangle or mall malfunctioning of the weight plates return.
Fixing cable onto Selector Shaft (Fig� D-8)
Before fixing the cable onto the selector shaft, all cables should be
routed throughout the station first.
The locking nut must be turned up fully as well.
- Fit the threaded cable end into the selector shaft by turning it in
clockwise direction as far as possible.
- Secure the fixation by turning the locking nut in clockwise direction
firmly.
⚠ WARNING
• All cables with threaded adjustable ends must have at least 1/2"
of the treads threaded in to its counter part. It is very important
that the jam nut be wrenched tightened to the counter part to
ensure that the threaded adjustable end of the cable does not
back out of its counterpart.
2 2

Publicité

loading

Ce manuel est également adapté pour:

Hg60 home gym