Removing / Inserting The Dust Container; Operation - Cleanmaxx PC-P008E Mode D'emploi

EN

Removing / Inserting the Dust Container

closed
open

Operation

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use,
empty the dust container. Empty and clean the dust container after each use. The
fi lter must also be cleaned regularly to prevent the motor from being overloaded.
■ Do not use the device when it is connected to the mains adapter.
• When the device is switched on, the charge status of the battery is indicated
by the two green battery charge status lamps (12). If both lamps are lit up, the
battery is full. If only the red operating lamp is lit up, the battery needs to be
charged up.
• If the suction power diminishes even though the battery is full, empty the dust
container (19).
• If the device is not going to be used for a lengthy period, take out the battery!
1. Select an accessory as required (see the "Device Overview" chapter, "Accessories"
section) and attach it to the device (see the "Assembly" chapter).
2. Switch on the device. To do this, press the On / Off switch (13).
– If it is only pressed lightly, the device automatically switches off again after it is
released. This is suitable for brief operation.
– For longer operation, press the On / Off switch (13) down fully. The device then
remains switched on even after you let go of the switch. To switch off the device,
the On / Off switch (13) must be pressed again.
3. Guide the nozzle over the surface to be cleaned.
4. After vacuuming, switch off the device, then empty the dust container (19) and clean
it if necessary (see the next "Cleaning and Storing the Device" chapter).
AZSXXL_DE-EN-FR-NL_A5_V3.indb 22 AZSXXL_DE-EN-FR-NL_A5_V3.indb 22
22
• Removing: Twist the dust container (19) a little bit. It is re-
leased from the motor unit (15) and can be removed.
• Inserting: Insert the dust container (19) into the motor unit
(15). Rotate it slightly as you do this until it engages in the
motor unit correctly. Then twist the dust container (19) in the
motor unit to secure it in place. The release button of the
dust container (19) must be located below the suction open-
ing (20) after it has been attached.
13.03.2018 08:10:36 13.03.2018 08:10:36