Removing / Inserting The Collecting Container; Use - Cleanmaxx Z 00890 Mode D'emploi

Removing / Inserting the Collecting Container

Use

CAUTION!
■ Never hold the nozzles close to parts of your body or animals during use and do
not place your hands inside the nozzles. They could become stuck to the device/
injured. Should the cordless vacuum cleaner become stuck, switch the device off
immediately.
■ Switch on the device only once you have ensured that the suction nozzle, the col-
lecting container, the fi lter compartment and the fi lter have been inserted correctly.
■ Always switch the device off fi rst before you attach or remove a nozzle!
■ On no account should the device be used to suck up the following:
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
■ Empty and clean the collecting container after every use or when the maximum fi ll
level (marking) is reached during use (see the "Cleaning the Device and Accessories"
chapter).
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge.
All manuals and user guides at all-guides.com
19
• Removing: Hold the device with the collecting container
pointing downwards and hold this securely. Press the release
button and remove the collecting container from the motor
unit.
• Inserting: On the bottom of the motor unit and on the collect-
ing container there is a wide locking lug. Hook the locking lug
of the collecting container under that of the motor unit and
press the two parts of the device together until they engage
and lock together. Then check whether the collecting contain-
er is fi tted in place properly.
■ IMPORTANT: If there is liquid in the collecting container,
do not overfi ll it or do not turn the device over with the
top pointing downwards so that no water can get into the
rectangular ventilation opening in the insert, and thus to
the motor!
1. Place one of the nozzles into the suction opening. However,
you can also use the cordless vacuum cleaner without a noz-
zle.
2. Switch on the cordless vacuum cleaner. To do this, slide the
On/Off switch to position 1.
EN