Assembly; Attaching / Removing Nozzles; Removing / Inserting The Dust Container - Cleanmaxx PC-P008E Mode D'emploi

d
6. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
7. Remove the battery from the charging station.

Assembly

Attaching / Removing Nozzles

With the exception of the electrical fl oor nozzle (9), all nozzles are attached with the aid
of the nozzle adapter (12).
• Plug the nozzle adapter into the suction opening (8) or the articulated suction tube.
Plug the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Floor Nozzle and Articulated Suction Tube
No adapter is required for the electrical fl oor nozzle (9) and the articulated suction tube.
• They are plugged directly onto the suction opening (8). The catches must be heard
to engage in place. Attach the electrical fl oor nozzle to the articulated suction tube
in the same way.

Removing / Inserting the Dust Container

closed
open
2. Insert the battery into the charging station. The three con-
tacts of the battery must rest on the three contacts (a) of
the charging station.
3. First plug the barrel connector on the cable of the mains
adapter (13) into the socket (c) of the charging station and
then connect the mains adapter to the plug socket.
a
4. The green operating lamp (b) and the red charge control
b
lamp (d) will light up. The battery is being charged.
5. When only the green operating lamp is still lit, the battery
c
is fully charged.
• To detach it, press the release button and pull the electri-
cal fl oor nozzle or the articulated suction tube out at the
same time.
• Removing: Twist the dust container (7) a little bit. It is re-
leased from the main unit (3) and can be removed.
• Inserting: Insert the dust container into the main unit. Ro-
tate it slightly as you do this until it engages in the main unit
correctly. Then twist the dust container in the main unit to
secure it in place. The release button of the dust container
must be located below the suction opening (8) after it has
been attached.
23 EN