Mounting/Removing Suction Nozzles; Removing/Inserting The Dust Bin; Operation - Cleanmaxx 07023 Mode D'emploi

EN
Adjusting the length of the telescoping tube

Mounting/removing suction nozzles

• Insert the open end of the telescoping tube in one of the enclosed suction nozzles
up to the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more fl exibility.
• To remove a suction nozzle pull it off.
Information regarding the animal hair fl oor nozzle:
When the animal hair fl oor nozzle is removed it can happen that the
adapter sleeve remains in place on the telescopic tube. Please note
that the other suction nozzles can only be applied to the telescopic tube
when the adapter sleeve has been removed from the tube!

Removing/inserting the dust bin

Operation

ATTENTION!
■ During use, always keep the nozzles away from body parts and animals and do not
reach into them. You could be caught or injured. If something does get caught in the
vacuum cleaner, turn it off immediately (depress the On/Off switch
■ Only turn on the vacuum cleaner once you are sure that all parts have been com-
pletely mounted and that the dust bin and the fi lter have been properly inserted.
■ To prevent the cord from becoming too hot when in use, pull at least two thirds of
its entire length out of the device before you switch on the vacuum cleaner. Do not
forcefully pull out the cord up to the stop point (no further than up to the red mark on
the cord) in order to prevent damage!
07023_DE-EN-FR-NL_A5_V1.indb 22 07023_DE-EN-FR-NL_A5_V1.indb 22
22
• Push the slider on the telescoping tube down and set the
desired length.
• Release the slider and move the tube forward until it locks
into place.
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is fac-
ing down and handle is facing up). Then push the han-
dle against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
).
04.08.2017 10:36:02 04.08.2017 10:36:02