Télécharger Imprimer la page

Rösle Gourmet G3 Mode D'emploi page 52

Publicité

Les langues disponibles

Les langues disponibles

If you follow these tips, your RÖSLE gas grill will give you many years of reliable service.
Each time before using the gas grill, check the gas grill for any leaks using a soapy solution or leak
detector spray.
The cooking surfaces (including burner cover) should be kept clean and dry after barbecuing, especially
after barbecuing with marinades. They contain salt and attack the surface.
You should rub a little oil into the surfaces of the grates after use.
Do not leave your grill outside unprotected. After the grill has fully cooled down, you must protect it
against rain and snow with a suitable RÖSLE protective hood. Do not store the grill beside road salt.
In order to prevent dampness, regularly remove the cover both in summer and winter so that the grill is
aired out and any accumulated moisture can be dispersed.
Do not store your grill when wet. Carefully dry it first.
Slight surface rusting can easily be removed with a cloth soaked in vinegar essence or with a commer-
cial rust remover. Observe the information of the cleaning agent manufacturer.
Chipped enamel can be treated with touching-up paint to cover over the bare metal exposed and
therefore avoid rust.
Check that the screw fixings are tight and that the wheels are firmly attached and turn freely.
Troubleshooting
Problem
Solution
Appliance does not
light, no flame,
burner fault
STOP, turn off the gas cylinder and turn all valves to "•" OFF!
Grill does not
function properly
DO NOT smoke.
Remove the gas hose from the gas grill. Turn on the gas cylinder just for a second to remove
any blockage from the hose. Turn off the gas cylinder again after a second and reconnect the
gas hose to the gas grill.
Remove the burners as described above. Check the gas valve outlets and use a thin metal
wire to remove any residues that might be causing a blockage. Place burner over the outlets
again and check whether the burner is now functioning properly.
No sparks
Uneven burner
Have the burners been cleaned? – Clean the burners, remove all residues.
flame pattern
Do not allow any water or cleaner to get into the burner jets.
Flash flames occur
52
Check whether the shut-off valve of the gas cylinder is open.
Make sure that there is enough gas in the cylinder.
Is there a kink in the gas hose? – Straighten out the hose.
Check whether sparks are jumping across from the electrode to the burner.
Is it possible to light the burner with a long match? – Check the ignition system!
Check all gas connections.
Wait 3 minutes to allow the accumulated gas to disperse and
then repeat the lighting procedure.
The burners are not properly fitted over the outlets:
Fit burners exactly over the outlets.
Gas pipe is blocked:
Blocked outlets:
Check the burner regularly in order to ensure that it is free of insects and spiders which
may block the gas system or impair the gas flow. Make sure that the Venturi tubes of the
burner are cleaned carefully so that there are no more obstacles. We recommend a tube
brush for cleaning the Venturi tubes.
The distance between the burner and the electrode should not be more than 5-8 mm.
If necessary, clean electrode and readjust it.
You may not have sufficiently preheated the grill. Preheat the grill for approx. 15 minu-
tes with all burners lit.
Clean the grill grates, fat catcher tray, etc., so that all fat deposits are removed.

Publicité

loading

Ce manuel est également adapté pour:

Gourmet g4