Insertingindividualparts
1. Place all necessary individual parts such as burner covers, grates
and warming rack in the grill.
2. Proceed carefully in order to avoid chipping the enamel of the
firebox.
"Burning-in"thegasgrill
Remove all stickers and labels from the lid window before "burning-in" the gas grill.
If you do not do so, the stickers and labels may melt and will then be very difficult to remove.
The gas grill emits a slight smell when used for the very first time. The smell is caused by the "burning-in"
of the interior coatings and burning of the lubricant from the production process.
This is quite normal and no longer occurs with further use.
1. Take out the grates and wash them with a mild detergent.
2. Refit the grates.
3. Before using the grill for the first time you should operate all main burners at full load and close the
lid. See section "Lighting the burners"
4. Depending on the model, also start all auxiliary burners and open the lids of the side tables.
See section "Lighting the burners"
5. Switch the appliance off after the 30-minute "burning-in" stage.
Lightingtheburners
Everyone who operates the appliance must be familiar with the lighting procedure. Children or
persons with reduced mobility must not be allowed to operate the grill. Never bend over the open
grill.
Always keep at least 30 cm away from the source of ignition when lighting the grill.
Keep your face, hair, beard, loose and flowing clothing, etc., well clear.
LightingprocedureformainburnerswiththeJetFlameignitionsystem
1. Before starting the lighting procedure, all control knobs must be set to the
position "•" OFF.
2. Open the lid of the grill before you light the main burners.
3. Open the gas cylinder valve by turning anticlockwise (at least two full turns).
4. Check all gas connections for leaks. See section "Leak check".
5. Press the desired control knob inwards and turn it slowly anticlockwise to
the "MAX" position or until you hear the click of the Jet Flame ignition
system.
42
3
2
1