Honda EM4500CXS Manuel De L'utilisateur page 19

4. PRE-OPERATION CHECK
CAUTION:
Be sure to check the generator on a level surface with the engine stopped.
Before each use, look around and underneath the engine for signs of oil or
gasoline leaks.
1. Check the engine oil level before each use.
CAUTION:
Using non detergent oil or 2-stroke engine oil could shorten the engine's
service life.
Use 4-stroke motor oil that meets or
exceeds the requirements for API service
category SE or later (or equivalent).
Always check the API service label on the
oil container to be sure it includes the
letters SE or later (or equivalent).
Read the instruction on the oil container
before use.
SAE 10W-30 is recommended for general
use. Other viscosities shown in the chart may be used when the average
temperature in your area is within the recommended range.
Lubrication oil specifications necessary to maintain the performance of the
emissions control system: Honda genuine oil.
a. Remove the oil filler cap/dipstick and wipe the dipstick clean.
b. Check the oil level by inserting the dipstick in the filler hole without screwing
it in.
c. If the oil level is low, fill with the recommended oil to the upper limit on the
oil filler cap/dipstick.
d. Reinstall the oil filler cap/dipstick securely.
CAUTION:
Running the engine with insufficient oil can cause serious engine damage.
NOTE:
The Oil Alert system will automatically stop the engine before the oil level falls
below the safe limit. However, to avoid the inconvenience of an unexpected
shutdown, it is still advisable to visually inspect the oil level regularly.
OIL FILLER HOLE
16
OIL FILLER CAP/
DIPSTICK
AMBIENT TEMPERATURE
UPPER LIMIT
LOWER LIMIT