Correct Utilisation - Burkert PTB 03 ATEX 1030 X Instructions De Service

1.3 Correct utilisation

The device may only be used for the applications indicated in the chapter
Operating conditions for the devices, and only in connection with third-party
devices or components recommended or approved by Bürkert. Observe
the instructions in this operating manual, as well as the conditions of use
and permissible data specified in the chapter Operating conditions for the
devices.
The proper and safe function of the system depends on proper transport,
storage and installation, and on careful operation and maintenance.
• The device serves exclusively as a solenoid valve for the media stated in
the data sheet and for use in Explosion Group II, Category 2G and Tem-
perature Class T4 or T5 (see data on the Ex approval plate
• The types of explosion protection used are flameproof enclosure „d" with
increased safety „e". The fuse incorporated in version K is executed in
explosion protection encapsulation type „m". The proximity switch which
can be optionally incorporated in all versions is executed in explosion
protection Intrinsic saftey „ia". The composition of the explosion protection
code follows the explosion protection types of the components used in
each case.
• Any other utilisation, or a utilisation going beyond this use will be regarded
as improper. Bürkert will accept no liability for any damage resulting from
such use. The user must bear all the risk alone.
NOTES!
The Qualification Test Certificate PTB 03 ATEX 1030 X can be found in
the Appendix. For the temperature classes and the electrical data, see
Technical Data.
).
03 ATEX 1030 X - 7