Montage - Burkert PTB 03 ATEX 1030 X Instructions De Service

WARNING!
Pressurised system!
Interventions in the pneumatic system represent an acute risk of injury.
• Work on the pneumatic system may only be carried out by qualified and
instructed personnel using appropriate tools.
• First switch off pressure before disconnecting lines and valves.
• Observe the flow direction during installation!
• Observe the applicable accident prevention and safety regulations for
pneumatic systems!

4.1 Montage

NOTES!
Installation in any position.
Preferably with solenoid system mounted at the top
Activity
Clean the pipe runs
Installation in any position
Connect a dirt-trap (strai-
ner) upstream
Seal
Screwing on the pipe run
Installation / Dismounting
Make electrical connec-
tions
Notes
-
Preferred direction with drive mounted
at the top
Note the direction of flow!
PTFE
Note the direction of flow!
Note
Always connect the earth conduc-
tor!
Note for units with connecting cable
The connecting cable and the coil are
moduled together. They must not be
dismantled!
-
03 ATEX 1030 X - 19